NEURAL DSP Adds A Looper To Their Quad Cortex

The CorOS 1.3.0 is now available for the Neural DSP Quad Cortex. The update offers a ton of new effects and amplifier models, but most importantly is that it finally offer a much-asked-for Looper.


The Quad Cortex Looper offers nearly 5 minutes of recording time, can be placed anywhere on The Grid allowing for creative routing configuration, and can be used in Preset/Scene/Stomp mode. The Looper is MIDI controllable and gives the following controls for all your looping needs:

  • Duplicate (create an overdub which is X times longer than your original loop, allowing you to extend your original loop when you are recording an overdub)
  • Re-Loop (trim the length of your loop when Duplicate is active)
  • One Shot (play the loop once and then stop)
  • Half Speed (play the loop at half speed)
  • Punch In (replaces the audio)
  • Overdub (record)
  • Play/Stop
  • Reverse (rewinds the loop)
  • Undo (undo the last action)

Check out CorOS 1.3.0 here and grab a Quad Cortex here.

No comments

leave a comment